Routing > OSPF > Areas
Routing
312
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
Buttons
Area LSA count Displays the total number of link state advertisements in the link state
database of this area, excluding AS External LSAs.
Area LSA
checksum
Displays the total number of LS checksums contained in the LS database of
this area. This sum excludes type 5 external LSAs. You use the sum to
determine if there has been a change in an LS database of a router, and to
compare the LS database to other routers.
Button Meaning
Set Transfers the changes to the volatile memory (
RAM
) of the device and
applies them to the device. To save the changes in the non-volatile
memory, proceed as follows:
Open the
Basic Settings > Load/Save
dialog.
In the table, highlight the desired configuration profile.
If in the "Selected" column the checkbox is
unmarked
, click the
"Select" button.
Click the "Save" button.
Reload Updates the fields with the values that are saved in the volatile memory
(
RAM
) of the device.
Create Opens the "Create" dialog to add a new entry to the table.
Specifies the "Area ID" for the new table entry.
Possible values:
– valid IP address
Remove Removes the highlighted table entry.
Help Opens the online help.
Parameters Meaning
To Next Page
Loading...