Routing > Routing Table
Routing
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
347
Type Displays the type of the route.
Possible values:
local
The router interface is directly connected to the destination network.
remote
The router interface is connected to the destination network through a
router ("Next Hop IP Address").
reject
The device discards IP packets addressed to the destination network
and informs the sender.
other
The route is inactive, see the "Active" checkbox.
Protocol Displays the origin of this route.
Possible values:
local
The device created this route when setting up the router interface; see
the
Routing > Interfaces > Configuration
dialog.
netmgmt
A user created this static route with the "Create" button.
Preference Specifies the "administrative distance" of the route.
The device uses this value instead of the metric, when the metric of the
routes is incomparable.
Possible values:
0
This value is reserved for routes that the device creates when setting
up the router interfaces. These routes have the value
local
n the
"Protocol" column.
1..254
In routing decisions, the device gives preference to the route with the
smallest value.
255
In routing decisions, the device ignores the route.
The "administrative distance" can be set for static routes created using the
"Create" button.
Metric Displays the metric of the route.
The device transmits the data packets using the route with the smallest
value.
Last Update [s] Displays the time in seconds, since the current settings of the route were
entered in the routing table.
Active Displays whether the route is active or inactive.
Possible values:
marked
The route is active; the device uses the route.
unmarked
The route is inactive.
Parameters Meaning
To Next Page
Loading...