Routing > L3-Redundancy > VRRP > Configuration
Routing
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
369
Tracking
Ping Answer Activates/deactivates the ping answer function on the device. You use the
VRRP ping for connectivity analyses.
The prerequisite for allowing the device to answer ping requests from the
interfaces is that you activate the "Send Echo Reply" function globally. In
the
Routing > Routing Global
dialog, "ICMP Filter" frame, mark the
"Send Echo Reply" checkbox.
Possible values:
unmarked
The "Ping Answer" function on the device is inactive.
The device ignores ICMP ping requests.
marked
(default setting)
The "Ping Answer" function on the device is active.
The device answers ICMP ping requests.
VRRP Master
Candidate
Primary virtual router IP address.
Physical routers within a virtual router instance use the VRRP IP address
to communication with themselves. If the virtual router IP address is the
same as an IP address of a router interface, then the router is the “owner”
of the IP address and is the master router.
Possible values:
valid IP address (default setting:
0.0.0.0
)
Parameters Meaning
Current Track Entries
Type Displays the type of the tracking object.
Possible values:
interface
The device monitors the link status of its physical ports or of its link
aggregation, LRE or VLAN router interface.
ping
The device monitors the route to a remote router or end device by
means of periodic ping requests.
logical
The device monitors tracking objects logically linked to each other and
thus enables complex monitoring tasks.
Track ID Displays the identification number of the tracking object.
Track Name Displays the name of the traffic object made up of "Type" and "Track ID".
Parameters Meaning
To Next Page
Loading...