Routing > NAT > Masquerading NAT > Rule
Routing
402
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
Buttons
Trap Activates/deactivates the sending of SNMP traps when the rule is applied
to data packets.
Possible values:
marked
The device sends an SNMP trap when it applies the rule to a data
packet.
unmarked
(default setting)
The sending of SNMP traps is deactivated.
The prerequisite for sending SNMP traps is that you enable the function in
the
Diagnostics > Status Configuration > Alarms (Traps)
dialog and
specify at least 1 SNMP manager.
Active Activates/deactivates the NAT rule. With this function you disable the NAT
rule temporarily without the need to enter the parameters again.
Possible values:
marked
The NAT rule is active.
unmarked
(default setting)
The NAT rule is inactive.
To apply the changes to the data stream, click in the
Routing > NAT > NAT
Global
dialog the "Commit Changes" button.
Button Meaning
Set Transfers the changes to the volatile memory (
RAM
) of the device and
applies them to the device. To save the changes in the non-volatile
memory, proceed as follows:
Open the
Basic Settings > Load/Save
dialog.
In the table, highlight the desired configuration profile.
If in the "Selected" column the checkbox is
unmarked
, click the
"Select" button.
Click the "Save" button.
Set and back Transfers the changes to the volatile memory (
RAM
) of the device and goes
back to the previous dialog.
Back Displays the previous dialog again. Changes are lost.
Reload Updates the fields with the values that are saved in the volatile memory
(
RAM
) of the device.
Create Adds a new table entry.
Remove Removes the highlighted table entry.
Help Opens the online help.
Parameters Meaning
To Next Page
Loading...