Advanced > DNS > Client > Static
Advanced
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
479
Buttons
Address Specifies the IP address of the DNS server.
Possible values:
Valid IPv4 address (default setting:
0.0.0.0
)
Active Activates/deactivates the table entry.
The device sends requests to the DNS server configured in the first active
table entry. If the device does not receive a response from this server, it
sends requests to the DNS server configured in the next active table entry.
Possible values:
unmarked
(default setting)
The device does not send requests to this DNS server.
marked
Allows the DNS client to send requests to this DNS server.
Prerequisites:
Enable the DNS-client function in the
Advanced > DNS > Global
dialog.
Select in the "Configuration" frame, "Configuration Source" field
the value
user
.
Button Meaning
Set Transfers the changes to the volatile memory (
RAM
) of the device and
applies them to the device. To save the changes in the non-volatile
memory, proceed as follows:
Open the
Basic Settings > Load/Save
dialog.
In the table, highlight the desired configuration profile.
If in the "Selected" column the checkbox is
unmarked
, click the
"Select" button.
Click the "Save" button.
Reload Updates the fields with the values that are saved in the volatile memory
(
RAM
) of the device.
Create Adds a new table entry.
Remove Removes the highlighted table entry.
Help Opens the online help.
Parameters Meaning
To Next Page
Loading...