Basic Settings > Port
Basic Settings
60
RM GUI HiSecOS EAGLE20/30
Release
3.0
09/2015
Automatic
Configuration
Enables/disables the automatic selection of the operating mode for the
port.
Possible values:
marked
(default setting)
The port negotiates the operating mode independently using
autonegotiation and detects the devices connected to the TP port
automatically (Auto Cable Crossing). This setting has priority over the
manual setting of the port.
Elapse several seconds until the port has set the operating mode.
unmarked
The port operates with the values you specify in the "Manual
Configuration" column and in the "Manual Cable Crossing (Auto. Conf.
off)" column.
Manual
Configuration
Specifies the operating mode of the device ports when the function
"Automatic Configuration" is inactive.
Possible values:
10 Mbit/s HDX
Half duplex connection
10 Mbit/s FDX
Full duplex connection
100 Mbit/s HDX
Half duplex connection
100 Mbit/s FDX
(default setting on TP ports)
Full duplex connection
1000 Mbit/s FDX
(default setting on optical ports)
Full duplex connection
The operating modes actually available depend on the media module
used.
Link/ Current
Settings
Displays the operating mode which the device port currently uses.
Possible values:
–
No cable connected, no link.
10 Mbit/s HDX
Half duplex connection
10 Mbit/s FDX
Full duplex connection
100 Mbit/s HDX
Half duplex connection
100 Mbit/s FDX
Full duplex connection
1000 Mbit/s FDX
Full duplex connection
Parameters Meaning
To Next Page
Loading...