Hirschmann HiSecOS EAGLE30 - Page 77

Time > NTP > Multicast Groups
Time
RM GUI HiSecOS EAGLE20/30
Release 3.0 09/2015
77
 Buttons
Status Displays the synchronization status.
Possible values:
 disabled
No server available.
 notSynchronized
The server is available. The server itself is not synchronized.
 notResponding
The server is available. The device does not receive time information.
 synchronizing
The server is available. The device receives time information.
 synchronized
The server is available. The device has synchronized its clock with the
server.
 genericError
Device-internal error.
Active Activates/deactivates the connection between the device and the
broadcast or multicast server.
Possible values:
 unmarked
The connection to the broadcast or multicast is deactivated.
 marked
The connection to the broadcast or multicast is activated.
The NTP client of the device obtains the time information from the
broadcast or multicast messages of this IP address.
Button Meaning
Set Transfers the changes to the volatile memory (
RAM ) of the device and
applies them to the device. To save the changes in the non-volatile
memory, proceed as follows:
 Open the
Basic Settings > Load/Save dialog.
 In the table, highlight the desired configuration profile.
 If in the "Selected" column the checkbox is
unmarked , click the
"Select" button.
 Click the "Save" button.
Reload Updates the fields with the values that are saved in the volatile memory
(
RAM ) of the device.
Create Adds a new table entry.
Remove Removes the highlighted table entry.
Help Opens the online help.
Parameters Meaning