This procedure describes how to back up and restore the configuration data.
Server blade
To back up the configuration data
The configuration data in server blade is automatically backed up every time
the server blade turns on or F/Ws are updated.
To restore the configuration data
1. [For CB 520A A1, CB 520H A1/B1/B2/B3/B4, CB 540A A1/B1, and Non-
SMP CB 520X B1/B2/B3]
Select Resources tab and select Modules > All Modules > Server
Blades > a target module that the data should be restored.
[For SMP CB 520X B1/B2/B3]
Select Resources tab and select Modules > All Modules > Server
Blades > Server Blade n of the SMP configuration > a target module
that the data should be restored.
2. Click Action and then select Restore server blade settings.
Figure 4-29 Restore configuration data for server blade
3. The restore dialog box appears. Check Restore all with latest backup
check box.
4. Click Confirm.
5. The confirmation dialog box appears. Click OK and then the firmware
restore process will be started.
6. After the firmware restore process has completed, the successful message
dialog box appears. Click Close.
Common process for replacement
4-31
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
