Replacing a memory card for LAN switch module
This procedure describes how to replace the memory card for 1Gb LAN switch
module and 1/10Gb LAN switch module.
Note: Do not remove the memory card when the Access LED (ACC) emits.
The data in the memory card may be corrupted.
Removing a memory card
1. Put on an anti-static wrist strap.
2. Push and remove the memory card from LAN switch module.
Figure 5-150 Removing a memory card
Installing a memory card
1. Put on an anti-static wrist strap.
2. Reverse the removal procedure.
Replacing a USB memory for 8Gb FC switch module
This procedure describes how to replace the USB memory for 8Gb FC switch
module.
Removing a USB memory
1. Put on an anti-static wrist strap.
2. Connect web console. See Web console login procedure on page 4-3
section.
3. Turn on LID LED for identifying the target module.
See
Identify LED (LID) on/off procedure on page 4-7 section.
4. Turn on the maintenance mode from web console.
Replacing parts
5-119
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
