24. Enter firmwareshow, and then press Enter key. Confirm that the
version is newly downloaded FOS version.
10Gb DCB switch module
1. Click Start > Programs > Accessories > Communications >
HyperTerminal to boot up terminal software.
2. The Connection Description window is displayed. Enter telnet1, and
then click OK.
3. Select TCP/IP (Winsock), enter < IP address > in the Host address,
and then click OK.
< IP address >:IP address of the target switch module. See
Internal IP
address setup procedure for switch module on page 4-18 section.
4. The login prompt is displayed in the terminal.
9-12
Updating firmware
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
