Installing a SAS-kit 2
1. Put on an antistatic wrist strap.
2. Connect the SAS cable to the HDD backplane board and the RAID
mezzanine card before installing.
CAUTION: To reduce the risk of the personal injury, connect the SAS
cable before the HDD backplane board and RAID mezzanine card are
installed in the server blade.
Figure 5-126 Connecting the SAS cable
3. Reverse the removal procedure.
4. Place the SAS cable into the guide of the air duct.
5. Perform Installing a full-wide server blade on page 5-7 procedure.
Notice:
Place the SAS cable to the cable guide correctly.
If the cable is not in place correctly, that might cause serious damage to
the cable.
Figure 5-127 Fixing the SAS cable- CB 540A A1/B1
5-98
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
