28. Static IP Address window is displayed. Confirm and record iSCSI
Target Name, iSCSI Target IP Address, TCP Port Number and Boot
Target.
29. Press Esc key.
30. Press Esc key until Controller Selection menu window is displayed.
Select the port#1-3, and then press Enter key.
Note: When the following message is indicated, pressEnter.
31. Repeat the procedures, step 19 to step 29.
End of the "Confirming the iSCSI settings".
Go to
Confirming the FCoE settings on page 7-65.
Confirming the UMC and Personality settings
This procedure shall be performed when the server model is neither CB 520H
B2/B3/B4 nor CB 520X B1/B2/B3, the firmware version of management
module is A0180 or later, and the firmware version of server blade is as
follows.
Server model Firmware version
CB 520H A1/B1 01-70 or later
CB 520A A1 02-38 or later
Configuring Emulex mezzanine card
7-63
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
