Hitachi CB 520H B3 - Replacing Parts

5
Replacing parts
This chapter describes how to remove and install parts on the Hitachi
Compute Blade system. The following key topics are covered:
□
Replacing a server blade
□
Replacing an SMP connection board for CB 520X B1/B2/B3
□
Replacing an expansion blade
□
Replacing a half-wide server blade for storage expansion blade
□
Replacing a half-wide server blade for PCI expansion blade
□
Replacing a PCI expansion blade
□
Replacing a disk drive
□
Preparing for replacing an internal component
□
Replacing a DIMM in half-wide server blade
□
Replacing a DIMM in full-wide server blade
□
Replacing a mezzanine card in half-wide server blade
□
Replacing a mezzanine card in full-wide server blade
□
Replacing a LOM pass through connector in half-wide server blade
□
Replacing a LOM pass through connector in full-wide server blade
Replacing parts
5-1
Hitachi Compute Blade 500 Series System Service Manual