Restoring the parameters of 8 Gb FC mezzanine card
1. Click Power and select Power On in Remote console menu.
2. Power Control dialog box is displayed. Click Yes.
The target server blade will power on.
3. Wait about five minutes until System Configuration and Boot
Management window is displayed.
Figure 7-3 Powering on the server blade
The following procedure varies depending on the server blade model.
For an FC mezzanine card on CB 520A A1, CB 520H A1/B1/B2, or CB
540A A1/B1, perform the following procedure.
For an FC mezzanine card on CB 520X B1/B2/B3 or CB 520H B3/B4, skip
to
Restoring parameter of FC mezzanine card on CB 520X B1/B2/B3, CB
520H B3/B4 on page 7-32.
4. Press Esc in System Configuration and Boot Management window.
5. Press Y when Do you want exit Setup Utility is prompted.
6. Confirm BIOS version, and then press Ctrl + E key in the following
prompt.
7-18
Configuring Emulex mezzanine card
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
