Restoring FCoE settings
This procedure shall be performed in all of the conditions except the server
blade is CB 520X B1/B2/B3 and CB 520H B3/B4.
1. Press Ctrl and E simultaneously in the following window.
FCoE BIOS Utility starts.
(Only when iSCSI is selected in Personality setting on one of the CNA
products, the line of iSCSI Initiator BIOS is indicated.
Only when FCoE is selected in Personality setting on one of the CNA
products, the line of FCoE BIOS is indicated.)
2. Move cursor onto the first Port of replaced CNA product by using ↑ and ↓
in FCoE BIOS Utility window, and then press Enter.
(Confirm the first Port of replaced CNA product according to the
following table.)
Note
1. Identify the first Port of replaced CNA product with the CNA
name and BUS number in Emulex Adapters in the System
window.
Configuring Emulex mezzanine card
7-95
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
