Replacing a PCI card in storage expansion blade
This procedure describes how to remove a PCI card from the storage
expansion blade.
Removing a PCI card
1. Put on an anti-static wrist strap.
2. Remove the target storage expansion blade.
See
Removing a storage expansion blade on page 5-11 section.
3. Open the top cover of the server blade. See
Opening a top cover, Server
blade on page 5-38 section.
4. Pull out the PCI card cage straight upward, as shown below.
5. Turn over PCI card cage.
Figure 5-85 Removing the PCI card cage
6. Loosen a screw on the PCI card cage.
7. Pull out hinge with screw from the PCI card cage bracket.
5-68
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
