Switch module
1Gb LAN switch module, 1/10Gb LAN switch module
To identify TOD;
1. Click Start > Programs > Accessories > Communications >
HyperTerminal to boot up terminal software.
2. The Connection Description window is displayed. Enter telnet1, and
then click OK.
3. Select TCP/IP (Winsock), enter < IP address > in the Host address
box, and then click OK.
< IP address >:IP address for the target switch module. See Internal IP
address setup procedure for switch module on page 4-18 section.
4. The login prompt is displayed in the terminal.
Figure 4-44 Login to the terminal software
5. Enter operator as login name, and then press Enter key.
6. Confirm that the command prompt is indicated.
Common process for replacement
4-49
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
