Figure 5-79 Removing the pass through mezzanine component
6. Grab the pass through mezzanine card shown as arrows A and B, then lift
up the pass through mezzanine card and remove it from the server blade
and storage expansion blade assembly.
Figure 5-80 Removing the pass through mezzanine component
Installing a pass through mezzanine card
1. Put on an anti-static wrist strap.
2. If the connector cover is installed in the slot where you want to install the
spare mezzanine card, remove the cover from the slot first.
Replacing parts
5-65
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
