14. Select < 2 >, and then press Enter key.
15. Repeat from step 5 to step 13 for second port of the failed mezzanine
card.
16. Power off the server blade.
Restoring the parameters of 16 Gb FC mezzanine card
1. Click Power and select Power On in Remote console menu.
2. Power Control dialog box is displayed. Click Yes.
The target server blade will power on.
3. Wait about five minutes until System Configuration and Boot
Management window is displayed.
7-44
Configuring Emulex mezzanine card
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
