Hitachi CB 520H B3 - Page 390

See the following table.
CNA product
Indication in Emulex Adapters in the System
window
CNA name BUS:(HEX)
CB 520H A1/B1/B2 and CB 540A A1/B1
CB 520H B1 LOM OCl11102-F-HI Any
CB 540A B1 LOM #0 OCl11104-F-HI
PP
1
CB 540A B1 LOM #1
QQ
1
CNA mezzanine #a
2
OCml11104-F2-HI
WW
2
CNA mezzanine #b
2
XX
2
CNA mezzanine #c
2
YY
2
CNA mezzanine #d
2
ZZ
2
CB 520A A1
CNA mezzanine #1 OCml11104-F2-HI
XX
3
ZZ
3
CNA mezzanine #2
WW
3
YY
3
Notes:
1. The hexadecimal Bus number PP < QQ.
2. The #a, #b, #c, and #d following to the CNA mezzanine indicate the
number of the installation order of the mezzanine card. When three CNA
cars are installed, #a, #b, and #c are effective.
When #a < #b < #c < #d, the hexadecimal Bus number WW < XX < YY <
ZZ.
3. When two CNA mezzanine cards are installed, the hexadecimal Bus number
WW < XX < YY < ZZ.
2. When the BUS number and Dev number for the first Port of
replaced CNA product are not indicated in the window, skip this step.
Set the parameters from scratch.
3. Two ports are indicated for the onboard LOM on CB 520H B1/B2.
Four ports are indicated for the onboard LOMs on CB 540A B1, a CNA
mezzanine card, and a LAN mezzanine card, respectively.
3. Move cursor onto Enable/Disable Boot from SAN by using ↑ and ↓, and
then press Enter.
Select Enable or Disable as same setting as recorded one before the
replacement, and then press Enter.
7-96
Configuring Emulex mezzanine card
Hitachi Compute Blade 500 Series System Service Manual