4. Press ESC. The window in step 3 is displayed again.
Move cursor onto Configure Boot Devices by using ↑ and ↓, and then
press Enter.
Move cursor onto as same numbered line as the line indicated as Used
before replacing the failed CNA product, and then press Enter.
(Skip this step when the BIOS setting for the first port is set to
Disabled.)
5. Move cursor onto the numbered line which indicates as same DID or
WWPN setting as the line indicated as Used before replacing the failed
CNA product, and then press Enter.
(Skip this step when the Boot BIOS setting for the first port is set to
Disabled.)
Configuring Emulex mezzanine card
7-97
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
