6. Confirm that the number in the Use <↑/↓> to select starting LUN
(HEX) prompt is 00 in the following figure, and then press Enter.
(Skip this step when the Boot BIOS setting for the first port is set to
Disabled.)
Note: Do not change the setting.
7. Move cursor onto the numbered line which indicates as same LUN
number setting as the line indicated as Used before replacing the failed
CNA product, and then press Enter.
(Skip this step when the Boot BIOS setting for the first port is set to
Disabled.)
8. Move cursor onto Boot this device via WWPN when WWPN was
registered for the boot entry before replacing the failed CNA product, and
then press Enter.
Move cursor onto Boot this device via DID when DID was registered for
the boot entry before replacing the failed CNA product, and then press
Enter.
(Skip this step when the Boot BIOS setting for the first port is set to
Disabled.)
7-98
Configuring Emulex mezzanine card
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
