17. It takes about 30 minutes to update the firmware.
Confirm that "All packages have been downloaded successfully." is
indicated and the state returns to command prompt.
18. Enter reboot in command prompt, and then press Enter key.
When "Are you sure you want to reboot the switch [y/n]?" is
indicated, enter y, and then press Enter key.
19. About five minutes later after starting the reboot, make sure that Power
LED and Status LED of the FC switch module emit in green.
20. Press Enter key to login to FC switch module again.
21. Enter admin as login name, and then press Enter key.
22. Enter password as password, and then press Enter key. Confirm that
command prompt is displayed again
23. Enter firmwaredownloadstatus, and then press Enter key.
Confirm that a message of "Firmwaredownload command has
completed successfully." is indicated.
When message of "The commit operation has completed
successfully" is not indicated, wait for several minutes, and then retry
this step.
Updating firmware
9-11
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
