11. Enter upload, and then press Enter key.
12. Enter < backup file name.txt>, and then press Enter key.
13. Enter all, and then press Enter key.
14. Enter password, and then press Enter key.
15. The following message is displayed.
Tip: The backup configuration file is stored in the following folder.
C:\inetpub\ftproot
To restore the configuration data
1. Start the terminal software and connect the target switch module.
2. Enter admin as login name, and then press Enter key.
3. Enter password as password, and then press Enter key.
4. Confirm that the command prompt is indicated.
5. Enter switchdisable, and then press Enter key.
6. Enter configdownload, and then press Enter key.
7. Enter ftp, and then press Enter key.
4-40
Common process for replacement
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
