Figure 5-63 Removing the connector cover
3. Align the three alignment holes of mezzanine card with the guide pins, as
shown below.
4. Reverse the removal procedure.
5. Configure the parameters in the case of replacing Emulex HBA card.
See Configuration procedure for Emulex HBA card on page 7-2 section.
6. Perform Installing a half-wide server blade on page 5-5 procedure.
Figure 5-64 Installing the mezzanine card
Notice:
Restriction; The half wide server blade with LOM cannot install the
mezzanine card at the slot number 1 because the LOM pass through
connector is already mounted in the server blade that supported the LOM.
The LOM pass through connector is not a replaceable component.
5-50
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
