14. Select to be set LUN line, and then press Enter when the LUN to be
registered is indicated in line #01.
15. Select Boot this device via WWPN when WWPN was registered in boot
entry before the replacement, or select Boot this device via DID when
DID was registered in boot entry before the replacement, and then press
Enter.
16. Record the registered boot entry.
When multiple boot entries are registered, repeat Step #11 to Step #15
for each entry, and then write down the registered boot entry
7-30
Configuring Emulex mezzanine card
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
