(Only when iSCSI is selected in Personality setting on one of the CNA
products, the line of iSCSI Initiator BIOS is indicated.
Only when FCoE is selected in Personality setting on one of the CNA
products, the line of FCoE BIOS is indicated.)
2. Move cursor onto the first Port of failed CNA product by using ↑ and ↓ in
FCoE BIOS Utility window, and then press the Enter.
(Confirm the first Port of failed CNA product according to the following
table.)
Note
1. Identify the first Port of the failed CNA product with the CNA
name and BUS number in Emulex Adapters in the System
window.
See the following table.
7-66
Configuring Emulex mezzanine card
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
