16. Confirm that the message, Completed update of F/W data., and OK in
the right side of the replaced CNA/LAN mezzanine card is indicated.
Note: The firmware update is performed for all of the controllers on the
CNA mezzanine card.
For example, the messages through Starting update of F/W data...
and Completed update of F/W data are indicated two times since a
CNA or LAN mezzanine card has two controllers.
17. Enter q in Select No. line, and then press Enter to complete the
firmware update.
7-78
Configuring Emulex mezzanine card
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
