Hitachi CB 520H B3 - Page 436

Confirming and updating firmware version for CB 540A B1,
CB 520H B2/B3/B4, CB 520X B1/B2/B3
Firmware earlier than shown below does not support Changing LOM
configuration. Before changing LOM configuration procedure, you need to
confirm firmware version. If firmware versions are earlier than shown below,
you need to update firmware version shown below or later.
On the other hand, if you want to backdate firmware earlier than shown
below, you need to enable LOM according to "
How to enable LOM. on page
10-8" section before backdate firmware.
Table 10-2 Firmware versions available for changing LOM configuration
Server blade
Firmware
BMC, EFI Management module
CB 540A B1 03-14 or later A0145 or later
CB 520H B2 04-30 or later A0205 or later
CB 520H B3 08-05 or later A0235 or later
10-4
Change LOM configuration
Hitachi Compute Blade 500 Series System Service Manual