Select Resources tab and select Modules > Server Blades > Server
Blade n of the SMP configuration > a target blade that should
update the FRU information.
2. Select Hardware tab.
3. Click Show FRU/Sensor.
4. The FRU/Sensor Information dialog box is displayed, click Edit > LOM
Type.
5. The Edit LOM type dialog box is displayed, select 0x00, and click
Confirm.
6. The Confirm dialog box is displayed, then click OK.
7. After the FRU update process has completed, the FRU/Sensor
Information dialog box is displayed again. Confirm that LOM type field
is 0x00.
10-6
Change LOM configuration
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
