Step Symptom Possible Cause Actions / Verifications
Action 2
1. Press the power switch to power on the
suspected server blade.
Verification 2
1. If the Power LED is solid green, then the
repair is completed.
2. If the symptom still exists, then go to
step 6.
2. • A server
blade does
not power
up.
• Power LED:
Blink.
• Error LED:
On
• Fault LED:
Off
Configuration
Error
Action 1
1. Verify the Error Status through the web
console.
2. Remove the suspected server blade.
3. Inspect the connector for damage.
4. Review the type and position of each
component (Processor, DIMM and
Mezzanine card).
5. Install it into the original bay again if it
did not have damaged connector.
Verification 1
1. If the Power LED starts blink in green and
Error/Fault LEDs are off, go to Action 2.
2. If the suspected server blade has
damaged connector, then go to step 6
3. If the symptom still exists, then go to
step 6.
Action 2
1. Press the power switch to power on the
suspected server blade.
Verification 2
1. If the Power LED is solid green, Error/
Fault LEDs are off, and power up is
successful, then repair is completed.
2. If the symptom still exists, then go to
step 6.
3. • A server
blade does
not power
up.
• Power LED:
Blink.
• Error LED:
On
• Fault LED:
On
Hardware Error Action 1
1. Verify the Error Status through the web
console.
2. Remove the suspected server blade.
3. Replace the suspected component(s)
identified by the web console.
4. Install it into the original bay again.
Verification 1
1. If the Power LED starts blink in green and
Error/Fault LEDs are off, go to Action 2.
2. If the suspected server blade has
damaged connector, then go to step 6
11-8
Troubleshooting
Hitachi Compute Blade 500 Series System Service Manual
To Next Page
Loading...
