Hitachi PSC-A1T - Page 117

2 Select “Yes” by pressing “ ” or “ ” and press “OK”. The set-
ting will be conrmed and the screen will return to the normal
mode.
OK
Fix desired mode?
VENTI
Yes No
SEL. ENT
.R
TN.
OK
OK

Setting of Total Heat Exchanger
This function is used to change the ventilation mode of the total heat exchanger.
NOTE
This function is available only when the total heat exchanger is connected. This function cannot be set when the unit is operating.
1 Select “Total Heat Exchanger SET” from the menu and press
“OK”. The total heat exchanger set is displayed then.
Menu
Motion Sensor Setting
Total Heat Exchanger SET
VENTI
Louver Open/Close
02
/
03
Louver Setting
15:10(Fri)
ENT
.R
TN.SEL.
OK
OK
OK
2 By repeatedly pressing “ ” or “ ”, the indication is changed
in order of AUTO VENTI
THEX VENTI Normal
VENTI. Select the operation target and press “OK”, then the
conrmation screen is displayed.
OK
Total Heat Exchanger SET
VENTI Mode
THEX VENTI
ENT
.R
TN.ADJ
OK
OK
3 Select “Yes” by pressing “ ” or “ ” and press “OK”. The set-
ting is conrmed and the screen returns to the normal mode.
OK
Fix setting of
total heat exchanger?
Total Heat Exchanger SET
Yes No
SEL. ENT
.R
TN.
OK
OK
4 Individual remote controls
PC-ARF
TCGB0106 rev.0 - 12/2014
101
4