4 Individual remote controls
Receiver kit for wireless remote control
TCGB0106 rev.0 - 12/2014
203
4
5
Attach the receiver kit to the lower cover.
a.
Insert the receiver kit and the connecting cable to the position for receiver kit.
b.
Lead the connecting cable through the hole for connecting cable.
c.
Catch 3 hooks of receiver kit onto the square hole. Pay attention to the direction of receiver kit when it is attached.
Receiver Kit
Attaching DIrection for
Receiver Kit
Hook
Receiver Kit
Service Hole
Hole for Connecting
Cable
Hook
NOTE
Check whether the receiver kit is securely xed.
6
Lead the connecting cable into the electrical box with other wires.Attach the accessory insulation to the edge of side
cover R in order to prevent a scratch by contacting the connecting cable to the edge of side cover R.
Side Cover R
Side Cover R
Insulation
Put the side cover R and the ange at
lower cover between insulations.
Connecting Cable for Receiver Kit
Lower Cover
Lower Cover
7
Remove the electrical box cover. Connect the connecting cable to the terminals A and B at the terminal board for re-
mote control switch as following gure. (There are no polarity between terminals A and B.)
Electrical Box
Terminal Board for Remote
Control Switch
Connecting Cable for R
Mark Band B
Mark Band A
Printed Circuit Board (PCB1)
To Next Page
Loading...
