5 Tap “Register” to register the sub units while the group and indoor units are selected.
• If the group and indoor units for the sub units are not selected, the “Register” indication is greyed out and therefore
cannot be tapped.
• The colour of the buttons of the registered group and the indoor unit changes to purple.
Tap buttons “<” and “>” on the upper left of the touchscreen to continue with the setting of another Block, or tap the “Set-
ting complet.” button to exit.
(4)
(5)
6 Tap “Setting complet.” on “Group Register (Sub Unit Register)” to return to the “Group Register” screen.
(6)
7 Tap “Monitor screen” to return to Monitor screen.
8 Tap “Service Menu” to return to Service Menu screen.
(8)
(7)
NOTE
It is possible to register a maximum of 15 sub
units in the same remote control group.
It is not possible to register an indoor unit with-
out remote control switch as a sub unit. (Refer to
Group Register section).
5 Centralised remote controls
PSC-A32MN
TCGB0106 rev.0 - 12/2014
309
5
To Next Page
Loading...
