Cancellation of group registration
1
Select “Group Register” on the screen of “Service Menu”. Refer to “Registration of a group (Main unit)”.
NOTE
This function cannot be selected when the external input signal is input to the external input terminal 1 or 2.
2
Select “Main Unit Register (or Sub Unit Register)” on the screen of “Group Register”.
3
Select the group to cancel registration.
•
Tap buttons “<” and “>” on the upper left of the touchscreen to switch the block display.
•
Select a group button by tapping it. The selected button is highlighted with an orange outline. If the selected group
button is tapped again, the group selection is cancelled.
4
Tap “Cancel register” to delete the register of the group. The group button and indoor unit button turn to grey.
•
When tapping “Cancel register” on the “Main Unit Register” screen, the main unit and the sub units are unregistered.
•
When tapping “Cancel register” on the “Sub Unit Register” screen, the sub units are unregistered.
Tap buttons “<” and “>” on the upper left of the touchscreen to continue unregistering groups in other blocks, or tap the
“Setting complet.” button to exit.
(2) (3)
(4)
5
Tap “Setting complet.” to return to the “Group Register” screen.
6
Tap “Monitor screen” to return to Monitor screen.
7
Tap “Service Menu” to return to Service Menu screen.
(7)
(6)
5 Centralised remote controls
PSC-A32MN
TCGB0106 rev.0 - 12/2014
310
To Next Page
Loading...
Need help?
General
