Checking of group registration (Checking of main unit register)
1 Select “Group Register” on the “Service Menu” screen. Refer to section Registration of a group (Main unit).
NOTE
This function cannot be selected when the external input signal is input to the external input terminal 1 or 2.
2 Select “Main Unit Register” (or “Sub Unit Register”) on the “Group Register” screen.
3 Tap “Check Setting” on the lower left of the touchscreen.
(2)
(3)
4 The screen switches to the Group Register check screen then. Tap “To Main Unit Reg.” to enter the Main Unit Regis-
ter screen from there.
5 Tap “Setting completed” to return to the Group Register Menu screen.
6 Tap “Monitor screen” to return to Monitor screen.
7 Tap “Service Menu” to return to Service Menu screen.
(4)
(5)
(7)
(6)
5 Centralised remote controls
PSC-A32MN
TCGB0106 rev.0 - 12/2014
311
5
To Next Page
Loading...
Need help?
General
