Copy of group or block name
1 Select “Group Name Register” at the “Menu” screen.
2 Select the source group or block to copy.
The button of the selected group or block appears highlighted with an orange frame.
Press the button of the selected group or block again to cancel the selection. The orange frame disappears then.
(2)
3 Select the destination group or block to paste.
It is possible to select multiple groups or blocks for destination.
The buttons of the selected groups or blocks are indicated with a “
” check mark.
To cancel the selection, press the button of the selected group or block again. The “
” check mark disappears then.
4 Tap “Paste” to copy the name of the group or block to the selected destination.
Go back to step (3) to copy the name of other groups or blocks.
Proceed to step (6) to nish.
5 Tap “Return to Group sel.” to return to the “Group Name Register” selection screen.
(5)
(4)
(6)
5 Centralised remote controls
PSC-A32MN
TCGB0106 rev.0 - 12/2014
342
To Next Page
Loading...
