HP 5800 Series User Manual

104
View
Any view
Default level
0: Visit level
Parameters
-a source-ip: Specifies the source address for the echo request messages to be sent.
-c count: Specifies the number of echo request messages to be sent. The count parameter ranges from 1
to 4,294,967,295 and defaults to 5.
-exp exp-value: Specifies the EXP value for the echo request messages. The exp-value parameter ranges
from 0 to 7 and defaults to 0.
-h ttl-value: Specifies the TTL value for the echo request messages. The ttl-value parameter ranges from 1
to 255 and defaults to 255.
-m wait-time: Specifies the interval for sending echo request messages. The wait-time parameter ranges
from 1 to 10,000 milliseconds and defaults to 200 milliseconds.
-r reply-mode: Specifies the reply mode of the receiver in response to the echo request messages. The
reply-mode parameter can be 1 or 2, where 1 means “Do not respond” and 2 means “Respond using a
UDP packet.” The default is 2.
-s packet-size: Specifies the payload length of the echo request messages. The packet-size parameter
ranges from 65 to 8100 bytes and defaults to 100 bytes.
-t time-out: Specifies the timeout interval for the response to an echo request message. The time-out
parameter ranges from 0 to 65,535 milliseconds and defaults to 2000 milliseconds.
-v: Displays detailed response information.
ipv4 dest-addr mask-length: Specifies to check the validity and reachability of the LSPs for a FEC. dest-
addr is the destination address of the FEC. The mask-length parameter is the length of the FEC destination
address mask and ranges from 0 to 32.
destination-ip-addr-header: Specifies the destination address in the IP header of MPLS echo request
messages. It can be any address on segment 127.0.0.0/8—any local loopback address.
Examples
# Check the connectivity of the LSP to destination 3.3.3.9/32.
<Sysname> ping lsp ipv4 3.3.3.9 32
LSP Ping FEC: LDP IPV4 PREFIX 3.3.3.9/32 : 100 data bytes, press CTRL_C to break
Reply from 100.1.2.1: bytes=100 Sequence=0 time = 31 ms
Reply from 100.1.2.1: bytes=100 Sequence=1 time = 62 ms
Reply from 100.1.2.1: bytes=100 Sequence=2 time = 62 ms
Reply from 100.1.2.1: bytes=100 Sequence=3 time = 62 ms
Reply from 100.1.2.1: bytes=100 Sequence=4 time = 62 ms
--- FEC: LDP IPV4 PREFIX 3.3.3.9/32 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 31/55/62 ms

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)