HP 5800 Series User Manual

212
Field Description
LinkID ID of the PW in the VPLS instance
VCState Status of the VC
# Display the detailed information of VPLS connections of VPLS instance aaa.
<Sysname> display vpls connection vsi aaa verbose
VSI Name: aaa Signaling: ldp
**Remote Vsi ID : 500
VC State : up
Encapsulation : vlan
Group ID : 0
MTU : 1500
Peer Ip Address : 1.1.1.9
PW Type : label
Local VC Label : 1024
Remote VC Label : 1024
Link ID : 1
Tunnel Policy : --
Tunnel ID : 0x3703ae
Table 85 Command output
Field Description
VSI Name Name of the VPLS instance
Signaling PW signaling protocol used by the VPLS instance
Remote Vsi ID ID of the VPLS instance
VC State Status of the virtual circuit
Encapsulation Encapsulation type of the VPLS instance
MTU Maximum transmission unit of the VPLS instance
Peer Ip Address IP address of the peer of the VPLS instance
PW Type
PW type, which can be:
• label: NPW, the PW with a PE
• MEHVPLS: UPW, the PW with a UPE
Link ID ID of the PW in the VPLS instance
NOTE:
You can use VCCV to verify the connectivity of a
PW only if the two peers support at least one identical
CC type and one identical CV type.
display vsi
Description
Use the display vsi command to display information about a specific VPLS instance or all VPLS instances.
Related commands: vsi.

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)