HP 5800 Series User Manual

105
prefix-label advertise
Description
Use the prefix-label advertise command to configure LDP to advertise prefix-based labels through remote
sessions.
Use the undo prefix-label advertise command to restore the default.
By default, LDP does not advertise prefix-based label through a remote session.
A device can advertise prefix-based labels to its remote peers through remote sessions only after you have
configured the prefix-label advertise command. However, a device can receive labels advertised by its
remote peers no matter whether you have configured this command or not.
After the device receives labels advertised by the peer, the corresponding LDP LSP can be established if
the following conditions are satisfied:
• The FEC’s outgoing interface is the MPLS TE tunnel interface.
• The destination address of the MPLS TE tunnel, the remote peer address specified through the
remote-ip command, and the LSR ID of the remote peer are the same.
• The MPLS TE tunnel interface is enabled with the MPLS capability.
Syntax
prefix-label advertise
undo prefix-label advertise
View
MPLS LDP remote peer view
Default level
2: System level
Parameters
None
Examples
# Configure LDP to advertise prefix-based labels through a remote session.
<Sysname> system-view
[Sysname] mpls ldp remote-peer bji
[Sysname-mpls-ldp-remote-bji] prefix-label advertise
remote-ip
Description
Use the remote-ip command to configure the remote peer IP address.
Use the undo remote-ip command to remove the configuration.
The remote peer IP address must be the MPLS LSR ID of the remote peer. Two peers use their MPLS LSR
IDs as the transport addresses to establish the TCP connection.
Related commands: mpls ldp remote-peer.

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)