HP 5800 Series User Manual

378
Parameters
tunnel-policy-name: Specifies the name of the tunneling policy for the VPN instance, which is a string of 1
to 19 characters.
Examples
# Associate VPN instance vpn1 with tunneling policy po1.
<Sysname> system-view
[Sysname] tunnel-policy po1
[Sysname-tunnel-policy-po1] tunnel select-seq lsp load-balance-number 1
[Sysname-tunnel-policy-po1] quit
[Sysname] ip vpn-instance vpn1
[Sysname-vpn-instance-vpn1] route-distinguisher 22:33
[Sysname-vpn-instance-vpn1] tnl-policy po1
[Sysname-vpn-instance-vpn1] quit
# Associate the IPv6 VPN of VPN instance vpn3 with tunneling policy po1.
[Sysname] ip vpn-instance vpn3
[Sysname-vpn-instance-vpn3] route-distinguisher 11:33
[Sysname-vpn-instance-vpn3] ipv6-family
[Sysname-vpn-ipv6-vpn3] tnl-policy po1
vpn-target (VPN instance view/IPv6 VPN view)
Description
Use the vpn-target command to configure VPN targets for a VPN instance, an IPv4 VPN, or an IPv6 VPN.
Use the undo vpn-target command to remove the specified or all VPN targets of a VPN instance, an IPv4
VPN, or an IPv6 VPN.
By default, no VPN targets are configured and you must configure VPN targets when creating a VPN
instance, an IPv4 VPN, or an IPv6 VPN.
• VPN targets configured in VPN instance view is applicable to both the IPv4 VPN and the IPv6 VPN.
• VPN targets configured in IPv6 VPN view is applicable to only the IPv6 VPN.
• VPN targets configured in IPv6 VPN view takes precedence over that configured in VPN instance
view. If you configure VPN targets in both IPv6 VPN view and VPN instance view, those configured
in IPv6 VPN view are applied to the IPv6 VPN.
Syntax
vpn-target vpn-target&<1-8> [ both | export-extcommunity | import-extcommunity ]
undo vpn-target { all | vpn-target&<1-8> [ both | export-extcommunity | import-extcommunity ] }
View
VPN instance view, IPv6 VPN view
Default level
2: System level

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)