HP 5800 Series User Manual

227
View
Interface view
Default level
2: System level
Parameters
instance-id: Specifies a service instance ID ranging from 1 to 4094.
Examples
# Create service instance 100 on GigabitEthernet 1/0/10 and enter service instance view.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/10
[Sysname-GigabitEthernet1/0/10] service-instance 100
[Sysname-GigabitEthernet1/0/10-srv100]
shutdown (VSI view)
Description
Use the shutdown command to shut down the VPLS service of a VPLS instance.
Use the undo shutdown command to restart the VPLS service of a VPLS instance.
By default, the VPLS service of a VPLS instance is started.
When a VPLS instance is disabled, the system does not handle any service of the VPLS instance.
Syntax
shutdown
undo shutdown
View
VSI view
Default level
2: System level
Parameters
None
Examples
# Shut down the VPLS service of VPLS instance aaa.
<Sysname> system-view
[Sysname] vsi aaa
[Sysname-vsi-aaa] shutdown
site
Description
Use the site command to create sites for a VPLS instance.
Use the undo site command to remove sites of a VPLS instance.

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)