HP 5800 Series

218
Syntax
encapsulation { port-based | s-vid vlan-id [ only-tagged ] | tagged | untagged }
undo encapsulation
View
Service instance view
Default level
2: System level
Parameters
port-based: Matches all packets received on the current port.
s-vid vlan-id: Specifies a VLAN ID to match packets carrying the specified VLAN ID. If the specified VLAN
ID is the default VLAN ID (PVID) of the current port and the only-tagged keyword is not specified, the
service instance matches packets carrying the current port’s PVID tag as well as untagged packets.
only-tagged: Matches only tagged packets.
tagged: Matches all tagged packets received on the port.
untagged: Matches all untagged packets received on the port.
Examples
# On port GigabitEthernet 1/0/1, configure service instance 100 to match all packets received on the
port.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] service-instance 100
[Sysname-GigabitEthernet1/0/1-srv100] encapsulation port-based
[Sysname-GigabitEthernet1/0/1-srv100] quit
[Sysname-GigabitEthernet1/0/1] quit
# On port GigabitEthernet 1/0/2, configure service instance 101 to match packets carrying the VLAN
tag of 200.
[Sysname-GigabitEthernet1/0/2] service-instance 101
[Sysname-GigabitEthernet1/0/2-srv101] encapsulation s-vid 200 only-tagged
[Sysname-GigabitEthernet1/0/2-srv101] quit
# On port GigabitEthernet 1/0/2, configure service instance 102 to match all untagged packets.
[Sysname-GigabitEthernet1/0/2] service-instance 102
[Sysname-GigabitEthernet1/0/2-srv102] encapsulation untagged
encapsulation (VSI view)
Description
Use the encapsulation command to specify the encapsulation type of a VPLS instance.
By default, the encapsulation type of a VPLS instance is VLAN, which corresponds to the VPLS instance
PW encapsulation type of VLAN.
Syntax
encapsulation { bgp-vpls | ethernet | vlan }