HP 5800 Series User Manual

187
Parameters
ff: Sets the resource reservation style to FF.
se: Sets the resource reservation style to SE.
Examples
# Adopt the FF reservation style when setting up the CR-LSP tunnel for TE tunnel 0.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te resv-style ff
mpls te retry
Description
Use the mpls te retry command to configure the maximum number of tunnel setup retries.
Use the undo mpls te retry command to restore the default.
The default maximum number of tunnel setup retries is 10.
You may configure the system to attempt setting up a tunnel multiple times until it is established
successfully or until the number of attempts reaches the upper limit.
Related commands: mpls te timer retry.
Syntax
mpls te retry times
undo mpls te retry
View
Tunnel interface view
Default level
2: System level
Parameters
times: Specifies the number of tunnel setup retries, ranging from 1 to 4,294,967,295.
Examples
# Set the maximum number of tunnel setup retries to 20.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te retry 20
mpls te route-pinning
Description
Use the mpls te route-pinning command to enable route pinning.
Use the undo mpls te route-pinning command to restore the default.
By default, route pinning is disabled.
You cannot use the mpls te route-pinning command together with the mpls te reoptimization command.

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)