HP 5800 Series User Manual

152
Field Description
BackUpBW Backup bandwidth
Route Pinning Route pinning function
Retry Limit Maximum number of setup retries
Retry Interval Retry interval
Reopt State of the reoptimization function
Reopt Freq Reoptimization interval
Back Up Type Backup path type
Back Up LSPID Backup LSP ID
Auto BW State of the automatic bandwidth adjustment function
Auto BW Freq Automatic bandwidth adjustment interval
Min BW Lower limit for automatic bandwidth adjustment
Max BW Upper limit for automatic bandwidth adjustment
Current Collected BW Bandwidth information collected
Interfaces Protected FRR protected interfaces
VPN Bind Type Type of the binding, VPN or ACL
VPN Bind Value Value of the binding, the VPN instance name or ACL number
Car Policy Whether CAR policy is enabled
Tunnel Group
Whether the tunnel is the primary tunnel or backup tunnel in the
group.
Primary Tunnel
Tunnel ID of the primary tunnel. If the tunnel is the primary tunnel, – is
displayed for this field.
Backup Tunnel
Tunnel ID of the backup tunnel. If the tunnel is the backup tunnel, – is
displayed for this field.
Group Status
Status of the group. Displayed as - if no protection group is
configured.
Oam Status OAM defect detection status. – means OAM is not enabled.
display ospf mpls-te
Description
Use the display ospf mpls-te command to display TE LSAs in the LSDB.
Syntax
display ospf [ process-id ] mpls-te [ area area-id ] [ self-originated ] [ | { begin | exclude | include }
regular-expression ]
View
Any view
Default level
1: Monitor level

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)