HP 5800 Series

162
Where:
• Kb is the blockade multiplier
• refresh-time is the refresh interval for a reservation state.
When the blockade time expires, the blockade state on the node is removed.
Before configuring this command, enable RSVP-TE.
Related commands: mpls rsvp-te timer refresh.
Syntax
mpls rsvp-te blockade-multiplier number
undo mpls rsvp-te blockade-multiplier
View
MPLS view
Default level
2: System level
Parameters
number: Specifies the blockade multiplier, ranging from 3 to 255.
Examples
# Set the blockade multiplier to five.
<Sysname> system-view
[Sysname] mpls
[Sysname-mpls] mpls rsvp-te blockade-multiplier 5
mpls rsvp-te graceful-restart
Description
Use the mpls rsvp-te graceful-restart command to enable the GR capability for MPLS RSVP-TE.
Use the undo mpls rsvp-te graceful-restart command to disable MPLS RSVP-TE GR.
By default, GR capability is disabled for MPLS RSVP-TE.
Enable RSVP-TE hello extension before enabling RSVP-TE GR.
Syntax
mpls rsvp-te graceful-restart
undo mpls rsvp-te graceful-restart
View
MPLS view
Default level
2: System level
Parameters
None