HP 5800 Series User Manual

159
Syntax
modify hop ip-address1 ip-address2 [ include [ loose | strict ] | exclude ]
View
Explicit path view
Default level
2: System level
Parameters
ip-address1 ip-address2: Substitutes the IP address specified by the ip-address2 parameter for the IP
address specified by the ip-address1 parameter in the explicit path. The specified IP addresses could be
link IP addresses or router IDs of nodes.
include: Includes the IP address specified by the ip-address2 parameter on the explicit path.
loose: Indicates that the next hop is a loose node which is not necessarily directly connected to the
specified node.
strict: Indicates that the next hop is a strict node which must be directly connected to the specified node.
exclude: Excludes the IP address specified by the ip-address2 parameter from subsequent path
calculations.
Examples
# Replace IP address 10.0.0.125 on explicit path named p1 with IP address 10.0.0.200, and exclude
this new IP address from subsequent path calculations.
<Sysname> system-view
[Sysname] explicit-path path1
[Sysname-explicit-path-path1] modify hop 10.0.0.125 10.0.0.200 exclude
mpls rsvp-te
Description
Use the mpls rsvp-te command to enable RSVP-TE.
Use the undo mpls rsvp-te command to disable RSVP-TE.
By default, RSVP-TE is disabled.
• Enable RSVP-TE before you configure other RSVP-TE features.
• To enable RSVP-TE in MPLS view, first enable MPLS in system view and MPLS TE in MPLS view.
• To enable RSVP-TE in interface view, first enable MPLS and MPLS TE in interface view.
• Disabling RSVP-TE in MPLS view disables RSVP-TE on interfaces.
Syntax
mpls rsvp-te
undo mpls rsvp-te
View
MPLS view, interface view
Default level
2: System level

HP 5800 Series Specifications

General

Brand	HP
Model	5800 Series
Category	Switch
Language	English