HP 5800 Series

220
mac-move enable
Description
Use the mac-move enable command to enable MAC address transition.
Use the undo mac-move enable command to disable MAC address transition.
By default, MAC address transition is enabled.
Syntax
mac-move enable
undo mac-move enable
View
VSI view
Default level
2: System level
Parameters
None
Examples
# Disable MAC address transition for the VPLS instance aaa.
<Sysname> system-view
[Sysname] vsi aaa
[Sysname-vsi-aaa] undo mac-move enable
mac-table limit
Description
Use the mac-table limit command to specify the maximum number of MAC addresses that can be learned
in the VPLS instance.
Use the undo mac-table limit command to restore the default.
By default, up to 524,288 MAC addresses can be leaned in the VPLS instance.
Syntax
mac-table limit mac-limit-number
undo mac-table limit
View
VSI view
Default level
2: System level
Parameters
mac-limit-number: Specifies the maximum number of MAC addresses, ranging from 1 to 524,288.
Examples
# Specify the maximum number of MAC addresses that can be learned in the VPLS instance aaa as 1024.