HP 5800 Series

194
-r reply-mode: Specifies the reply mode of the receiver in response to an Echo Request message. The
reply-mode parameter can be 1 or 2, where 1 means “Do not respond” and 2 means “Respond using a
UDP packet.” The default is 2.
-s packet-size: Specifies the payload length of the Echo Request messages. The packet-size parameter
ranges from 65 to 8100 and defaults to 100, in bytes.
-t time-out: Specifies the timeout interval for waiting for the response to an echo request message. The
time-out parameter ranges from 0 to 65,535 and defaults to 2000, in milliseconds.
-v: Displays detailed response information.
te interface-type interface-number: Specifies a tunnel interface.
Examples
# Use the ping function to check the validity and reachability of the MPLS TE tunnel of tunnel interface
Tunnel 1.
<Sysname> ping lsp te tunnel 1
LSP Ping FEC: TE TUNNEL IPV4 SESSION QUERY Tunnel1 : 100 data bytes, press CTRL_C to
break
Reply from 100.1.2.1: bytes=100 Sequence=0 time = 31 ms
Reply from 100.1.2.1: bytes=100 Sequence=1 time = 62 ms
Reply from 100.1.2.1: bytes=100 Sequence=2 time = 62 ms
Reply from 100.1.2.1: bytes=100 Sequence=3 time = 62 ms
Reply from 100.1.2.1: bytes=100 Sequence=4 time = 62 ms
--- FEC: TE TUNNEL IPV4 SESSION QUERY Tunnel1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 31/55/62 ms
reset mpls rsvp-te statistics
Description
Use the reset mpls rsvp-te statistics command to clear statistics about RSVP-TE.
Syntax
reset mpls rsvp-te statistics { global | interface [ interface-type interface-number ]
View
User view
Default level
1: Monitor level
Parameters
global: Clears statistics about global RSVP-TE.
interface: Clears statistics about RSVP-TE for all interfaces.
interface interface-type interface-number: Specifies an interface by its type and number. If you specify an
interface, the command clears the statistics about RSVP-TE for the interface.