EasyManua.ls Logo

HP 5800 Series

HP 5800 Series
396 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
264
pw-class
Description
Use the pw-class command to create a PW class template and enter PW class template view.
Use the undo pw-class command to delete an existing PW class template.
By default, no PW class template is created.
Syntax
pw-class class-name
undo pw-class class-name
View
System view
Default level
2: System level
Parameters
class-name: Specifies the name of the PW class template, which is a case-insensitive string of 1 to 19
characters.
Examples
# Create PW class template pw100 and enter its view.
<Sysname> system-view
[Sysname] pw-class pw100
[Sysname-pw-pw100]
pw-tunnel-policy
Description
Use the pw-tunnel-policy command to specify the tunneling policy for a PW class template.
Use the undo pw-tunnel-policy command to restore the default.
By default, only one tunnel is selected (no load balancing) in this order: LSP tunnel, CR-LSP tunnel.
If you specify a nonexistent tunneling policy by using the pw-tunnel-policy command, the default
tunneling policy is used. The default tunneling policy selects only one tunnel (no load balancing) in this
order: LSP tunnel, CR-LSP tunnel.
For how to configure a tunneling policy, see the chapter “MPLS L3VPN configuration.
Related commands: tunnel-policy.
Syntax
pw-tunnel-policy policy-name
undo pw-tunnel-policy
View
PW class template view

Table of Contents

Other manuals for HP 5800 Series

Related product manuals